Reciprocating Compressor Performance and Safety Prediction for Control Panels


Published:

SECTION 1: Introduction

 

There are three general methods of modeling reciprocating compressor performance and safety prediction commonly used in unit control panel logic:

  • Fast and Easy
  • Covers 90% of Concerns
  • Covers Everything according to the Compressor Manufacturer (OEM)

 

When overseeing a compressor or compressor station, one needs to know which method is being implemented in each of your control panels (UCPs). If it’s not the OEM method, then there had better be a good reason why something inferior is being used, especially if the unit is damaged due to mechanical stresses.

 

Before discussing various modeling methods, it is important to note that real-time modeling of performance and safety is different than real-time variable measurement, such as actual discharge temperatures and internal cylinder pressures. Real-time modeling of performance and safety allows the PLC to predict unit performance and to identify ahead of time within its defined operating map where it is safe to run that unit, but it does assume that the unit is configured properly and that it is in reasonably good health. Real-time monitoring reviews unit performance based on actual unit configuration (healthy or damaged) and operating conditions, but provides no insight on how to get out of unsafe operations other than flag alarms and shut down.

 

OEM Performance and Safety Prediction is required as it provides useful predictions for achieving user goals, keeping units from overloading and out of unsafe areas. Adding optional real-time monitoring can help prevent continued operations in high mechanical stress (e.g. like high rod load forces due to valve breakages from slugs of liquids). Nevertheless, even if you choose to add real-time monitoring, you still must make sure that the real-time monitoring devices are modeling your equipment in accordance with OEM modeling specifications. Without this step, inappropriate shut downs or hardware damage can still occur.

Download the full PDF here or read the next article in the series:  Section 2: Evaluating The Methods

Archive »Archive »

CNG Export Proposal Pending

A Morgan Stanley subsidiary has applied to the U.S. Department of Energy for a permit to export up to 60 Bfcy (1.7 x 109 m3/y) of compressed natural gas (CNG) gas from a proposed terminal near Freeport, Texas.

Cameron Sells Centrifugal Division to Ingersoll Rand

Cameron is selling its centrifugal compression division to Ingersoll Rand (IR) for US$850 million as part of a long-term business strategy to focus on its core markets.

U.S. Gas Exports to Mexico Set Record

U.S. natural gas exports to Mexico were a record 2.5 Bcfd (70.8 x106 m3/d) on July 24 and averaged 2.3 Bcfd (65.1 x106 m3/d) from June through August, more than double the pipeline flow in 2010.

USA Compression Orders More Horsepower

USA Compression Partners LP, Austin, said its fleet horsepower has increased 38.9% to 1.3 million hp (1000 MW), compared to the same period last year, aided in part by its acquisition of 138,000 hp (103 MW) from S&R Compression in August 2013.

Compressco Partners Improves Utilization Rate

Compressco Partners of Oklahoma City reported that its average compressor fleet utilization rate was 85.3% during the second quarter, compared to 82.6% in the same period of 2013.